Nfe silverware

Good day,

I just flash nfe firmware on my whoop lite fc.

Everything is successful and was able to bind.

But when I armed the kwad just keeps on spinning on yaw axis. Didnt change the motors or prop direction. I just set the receiver and hardware type.

Please help.

The nfe silverware code defaults to “props out” configuration. Sounds like your motors and props are setup for “props in.” You can change it using stick gestures. Down Up Down on the right stick after binding. Then down down down to save. Or look in the config file and comment out the line that says invert yaw pid and reflash.

Ohh Will try this one. I thought that it will not matter bcos its brushed. will check on this. thanks a lot