Micro Motor Community

Hoverbot VIBE


#1

I have a Hoverbot Vibe, I’ve got everything soldered and bound and used the recommended settings on Hoverbots page and pasted them in the CLI. My FC is the right orientation and all of my motors are correct and are spinning the right direction. When I power on and arm the drone pops up a few inches and does a half turn the drops, and then will take no input from the transmitter. I have to disarm and then rearm and it will do the same thing over again. Not sure what to do at this point. Not sure if its a betaflight issue or a bad component. Any advice?