So i decided to start snipping and trimming and planning for the build.
I figured hey, let me get an idea of where im going to place things so let me build up this frame real quick and try to fit everything where I'd like it...
This is what it should pretty much look like, weighing in at 174g auw with battery strap and 277g so far with an tx 30 850mah 4s lipo! (Just above my goal of 250g, dang! But I should get about 5:30- 6 minutes flight
Time Cruising around. And this thing should rip too!
Most of the RTF 150s out there are coming with a 500-550mah battery size. I did some research and I found an xt30 4s 650mah tattuu battery that weighs 74g, which should put it at a total weight with at about 248g, which is more where I wanted to be in terms of weight for a 130mm! Not too bad looking for my first fpv micro build with hs1177 full sized camera lol
Still studying the FC, which is why I haven't attempted any soldering yet... I still have much to do!
I need to solder motor wires to 4in1ESC.
Then afterwards on the side I need to plug in HS1177 camera to 12v input and power it up and program it to the proper setttings.
Then I need to get down to soldering the motor signal wires 5v positive from littlebee and ground to the FC.
Then I need to solder on reciever. (Gotta research this a little more)
Then I need to solder the VTX to the littlebee 4in1 powerleads to power it, and hook up the hs1177 camera to be powered off the vtx.
Once all that is done, I can power up via smokestopper and if I get no smoke then I can plug into betaflight and try to program it all in from there!
(Sorry for posting my to do list, but I'll forget and lose track of my order of operations without doing so lol if anyone has any suggestions, or ideas I'm always willing to use them ! )