Does this continuity make sense?


#1

I resoldered some connectors to my Omnibus Nano V2 with OSD and I am getting some possibly weird continuity.

I get only 75 ohm resistance between GND and OSD Video In. If I check continuity, it says it’s shorted. Does that make any sense or when I plug in my Run cam Micro Swift and VTX03 I’m going to fry something?

My TX02 smoked, but there was a lot of wet grass on it earlier. And I don’t really remember, but I think my TX02 cam got friend when I plugged it directly into a whoop lipo.

If someone has a Omnibus Nano V2, could you please disconnect your camera and OSD and tell me the continuity between Vin (OSD In) and AGND (Camera Voltage GND)?